Building a Prusa Mendel and new SumoORE PCBs

Well, with the Ottawa robot games over and done with this year, I’ve been able to turn my attention to the 3D printer that I’ve been ordering parts for. As previously posted, this thing has been on the backburner since February when I picked up a set of printed parts. I had been thinking about one for even longer but never got started.

Seeing the quality of the printed parts coming out of the UP! printer that Paul over at MakerEngineering has raised my interest level. Now, I don’t have $3k to throw at a printer sadly so I’m building a Prusa Mendel instead. The do-it-yourself reprap print quality has been slowly climbing (recent print by Josef Prusa) and I think it is good enough that I’ll be able to make use of the parts in future robots. As well as let the kids go crazy making stuff. 😉

I’m about 2 hours into my build so far. I’ve got the basic frame of the printer built up. Next step is to cut out some wood plates for the y-axis on the bottom and then I can start bolting more on. My hot-end for extruding the plastic is still a week or two away (assuming it doesn’t get caught up in the strike) so I still have time.

20110612-080652.jpg

I also received a 2nd batch of SumoORE boards. The first batch is all built up now so I figured it was time to run a second set. I removed a couple of headers around the DC/DC charge pump and LiFEPO4 charger that ended up not being necessary as well as cleaned up the silkscreen.

This batch from Seeedstudio is fantastic quality. Its definitely hit or miss over there with iTead and Seeed. I’m starting to figure out how to easily tell between the crap PCB manufacturer and the good one though. The crap one turns the through holes on headers and stuff into hexagons instead of a true circle. The good one has beautiful round circles there instead. I can now pick up a PCB and tell within seconds whether I need to visually inspect the entire thing with my microscope before soldering.. 😉  Too bad there wasn’t some way of specifying which sub-contractor that iTead or Seeed was using to build boards.

20110612-080706.jpg

This entry was posted in PCB, RepRap, SumoORE. Bookmark the permalink.

3 Responses to Building a Prusa Mendel and new SumoORE PCBs

  1. Albert says:

    I sent your revision ones away to a place called EzPCB (I like your design :)). We have them as a sponsor for the UofS robotics club. I have also recently ordered from Seeed to try out the service. I noticed that they both had similar manufacturing markings. The ones from EzPCB were all e-tested. They offer educational sponsorship for up to 10 boards of 10x10cm 3 times a year, you just have to pay shipping. Right now they are all populated and waiting for the bootloader.

    • Aaron Ramsey says:

      Cool! I think I’ve used EzPCB in the last? That sounds like a great deal with the educational sponsorship.

      That reminds me that I’d better upload the latest chassis files to the wiki.ottawarobotics.org website. I made some very small tweaks to open up the rear IR window as well as fit some of the panels a little more tightly. When I ship your minisumo back I’ll toss in a chassis for you to check out.

      • Albert says:

        Thanks, that sounds great. I’m glad to say that 100% of the boards from EzPCB have worked. I messed up two because of backwards parts and hooking up power backwards. But they are all working now. I think I will put in a protection diode for the battery thing so it doesn’t happen again.

Leave a Reply to Albert Cancel reply

Your email address will not be published. Required fields are marked *